RAD Data comm ASMi-52L Spécifications télécharger pdf (Page 160)

Chapter 7 Application Tutorial Installation and Operation Manual

7-4 Equipment List ASMi-52 Ver. 2.5

Figure

7-6. Connecting STATION CLK to Clock Generator

6. Power up the LRS-16 unit. Verify that the PS1 and/or PS2 LEDs in the front

panel are lit.

7. Verify LRS-16 correct startup by observing the state if the PS LED(s) are as

follows:

 On (Green) – power supply is on

 On (Red) – power supply is not connected to the mains

 Off – power supply is off.

Configuring the Local LRS-16

This section explains how to configure LRS-16. When the process is completed,

the configuration file is transferred to the LRS-16 unit.

Refer to

Chapter 3

for explanation of how to select management options and

save the changes.

Accessing LRS-16

Usually, initial configuration of the management parameters is performed via an

ASCII terminal or a network management station (NMS). Once the LRS-16 host IP

parameters are set, it is possible to access it via Telnet, ConfiguRAD, or RADview

(a network management station – NMS) for operation configuration.

³ To access LRS-16:

1. Connect your PC to the LRS-16 CONTROL port.

2. Set your terminal emulator with the following parameters:

• Baud rate – 9,600

• Data bits: – 8

• Stop bits – 1

• Parity –None

• Flow control – None

3. Set the terminal emulator to VT100 emulation for optimal view of system

menus. If you are using HyperTerminal, set the terminal mode to 132-column

Copper Cable

with DB-15 Connectors

Station Clock Port

1 2 ... 155 156 157 158 159 160 161 162 163 164 165 ... 183 184

Pas de commentaire

RAD Data comm ASMi-52L Spécifications Page 160