RAD Data comm FCD-IP Manuel d'utilisateur télécharger pdf (Page 80)

Chapter 5 Performance RADview FCD-IP User’s Manual

5-2 Performing Diagnostic Tests

5.2 Setting the Polling Interval

RADview enables you to set the current statistics polling interval to automate

FCD-IP statistics updates, per assigned elapsed time intervals.



To set the polling interval:

1. Select a Link or Channel.

2. Select Statistics >Physical Layer > Polling Interval…

Select Statistics >Physical Layer > SHDSL > Polling Interval…

The Polling Interval dialog box appears (Figure 5-1).

3. Enter the polling interval in seconds and check the Polling Enable checkbox.

4. Click <Set>.

Figure 5-1. Polling Interval

5.3 Performing Diagnostic Tests

RADview enables you to run diagnostic tests.

When configuring TDM (E1/T1) parameters a password is required.



To run diagnostics tests:

1. Select a Link or Channel.

2. Select Diagnostics >Test…

The Testing dialog box appears.

Figure 5-2. Testing

Note Note

1 2 ... 75 76 77 78 79 80 81 82 83 84 85 ... 109 110

Pas de commentaire

RAD Data comm FCD-IP Manuel d'utilisateur Page 80