RAD Data comm FCD-IP Manuel d'utilisateur télécharger pdf (Page 57)

RADview FCD-IP User’s Manual Chapter 3 Port Management

Configuring Physical Parameters 3-19

Table 3-14. General Link Parameters (E1/T1 Ports) (Cont.)

Parameter Possible Values / Remarks

RAI The Remote Alarm Indication (for main links with sub links).

Off, On

For main links:

On transmits a yellow alarm indication on the E1 sub link when Link 1 is in yellow

alarm state .

For Sub links:

On transmits a yellow alarm indication on Link 1 when sub link E1 is in either yellow or

red alarm state.

Note: This field exists only when the E1/T1 has a sub link.

Inband Management The identifier of inband management over the link.

Off, Dedicated TS

TS Number TS being used as Dedicated TS

Only applicable when Inband Management=Dedicated TS.

Configuring E1/T1 Time Slot (TS) Assignments

RADview enables you to program the routing of time slots. A complete description

of the TS assignment function is discussed below.



To configure TS parameters:

1. Select a Link or Channel.

2. Select Configuration >Physical Parameters > TS Assign…

click the shortcut key on the toolbar

The TS Assignment dialog box appears.

Figure 3-13. TS Assignment

1 2 ... 52 53 54 55 56 57 58 59 60 61 62 ... 109 110

Pas de commentaire

RAD Data comm FCD-IP Manuel d'utilisateur Page 57