RAD Data comm FCD-IP Manuel d'utilisateur télécharger pdf (Page 34)

Chapter 2 System Management RADview FCD-IP User’s Manual

2-20 Configuring the Dynamic Host Configuration Protocol (DHCP)

Table 2-13. Dynamic Host Configuration Protocol Parameters (Cont.)

Parameter Possible Values / Remarks

Interface The interface through which the remote interface of the IP address is received.

All, LAN1

, LAN2, Any LAN, WAN

[Apply] To save changes in table, click <Apply>.

[Add…] To add an entry to the table, click <Add…>. Configure the parameters in the Add

DHCP Entry table and click <Set>. A maximimum of 10 entries is allowed in the

table.

[Change…] To change an entry, select it and click <Change…>.

Make desired changes in Change DHCP Entry table and click <Set>.

[Remove] To delete an entry, select it and click <Remove>.



To add an DHCP entry:

1. In the DHCP Table, click <Add…>.

The Add DHCP Entry dialog box appears.

Figure 2-20. Add DHCP Entry

2. Configure desired parameters (see Table 2-13).

3. Click <Set>.

The Add DHCP Entry dialog box closes.



To change a DHCP entry:

1. In the DHCP Table, click <Change…>.

The Change DHCP dialog box appears.

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 109 110

Pas de commentaire

RAD Data comm FCD-IP Manuel d'utilisateur Page 34