RAD Data comm IPmux-11 Spécifications télécharger pdf (Page 93)

IPmux-11 Ver. 2.00 Overview 5-1

Chapter 5

Configuring IPmux-11 for a

Typical Application

This chapter provides detailed instructions for setting up a typical application using

two IPmux-11 units.

5.1 Overview

Application

The section provides detailed instructions for configuring two IPmux-11 units

operating opposite each other (see

Figure 5-1).

Figure 5-1. Two IPmux-11 Units Operating Opposite Each Other

Guidelines for Configuring IPmux-11 Units

There are four basic configuration steps (described below) that need to be

followed when deploying any IPmux unit.

1. IP Configuration – Setting the device host IP address and the manager IP address.

2. Physical layer configuration – Setting the TDM parameters (line type, clocking,

etc.) according to the application requirements and topology.

3. Creating bundles – Allocating timeslots to bundles

4. Connecting bundles – Directing the bundles defined above to remote IPmux

unit.

1 2 ... 88 89 90 91 92 93 94 95 96 97 98 ... 147 148

Pas de commentaire

RAD Data comm IPmux-11 Spécifications Page 93