RAD Data comm IPmux-11 Spécifications télécharger pdf (Page 71)

Installation and Operation Manual Chapter 4 Configuration

IPmux-11 Ver. 2.00 Configuring IPmux-11 for Operation 4-13

Configuring IPmux-11 at the Physical Level

The TDM (E1 or T1) and Ethernet interfaces of IPmux-11 must be configured at

the physical level.

Configuration>Physical layer

1. TDM >

2. Eth >

3. External clock interface (Balance)

Please select item <1 to 3>

ESC-prev.menu; !-main menu; &-exit 1 Mngr/s

Figure 4-13. Physical Layer Menu

Configuring the E1 TDM Interface

The E1 and T1 interfaces of IPmux-11 are configured via the TDM menu.

IPmux-11 automatically detects whether the interface is E1 or T1, and displays the

appropriate menu.



To configure the E1 interface:

1. From the Configuration menu, select Physical layer.

The Physical Layer menu appears.

2. From the Physical Layer menu, select TDM.

The TDM (E1) menu appears (see

Figure 4-14).

3. From the TDM (E1) menu, configure the following:

 Admin Status:

 Enable (E1 link is enabled)

 Disable (E1 link is disabled)

 Transmit clock source:

 Adaptive (Adaptive clock regeneration)

 Loopback (E1 recovered Rx clock is used as the Tx clock)

 Internal (Tx clock is received from an internal oscillator)

 System (System clock is used as the Tx clock)

1 2 ... 66 67 68 69 70 71 72 73 74 75 76 ... 147 148

Pas de commentaire

RAD Data comm IPmux-11 Spécifications Page 71