RAD Data comm IPmux-11 Spécifications télécharger pdf (Page 73)

Installation and Operation Manual Chapter 4 Configuration

IPmux-11 Ver. 2.00 Configuring IPmux-11 for Operation 4-15

Configuration>Physical layer>TDM (E1)

Channel ID (1)

Restoration time >(CCITT)

Signaling mode (CAS Disabled)

1. Admin status (Enable)

2. Transmit clock source >(Adaptive)

3. Rx sensitivity (Short haul)

4. Trail mode (Termination)

5. Line type >(Framed G.704)

6. Idle code[0 - ff] ... (7E)

7. Send upon fail (OOS Code)

8. OOS Code[0 - ff] (FF)

(N)

Please select item <1 to 11>

ESC-prev.menu; !-main menu; &-exit 1 Mngr/s

Figure 4-14. TDM (E1) Menu (Page 1)

Configuration>Physical layer>TDM (E1)

...(P)

9. OOS signaling > (Space)

10. Mark signaling code[0 - f] ... (D)

11. Space signaling code[0 - f] ... (1)

Please select item <1 to 11>

ESC-prev.menu; !-main menu; &-exit 1 Mngr/s

Figure 4-15. TDM (E1) Menu (Page 2)

Configuring the E1 External Clock Interface

For the units with the E1 user interface it is necessary to define the external clock

interface type: balanced or unbalanced. When it is set to unbalanced, connection

to the external clock source must be performed via CBL-RJ45/2BNC/E1/X adapter

cable.



To configure the external clock E1 interface type:

• From the Physical Layer menu (Configuration > Physical Layer), select

External Clock Interface and choose its type: balanced or unbalanced.

Configuring the T1 TDM Interface

The procedure for configuring the T1 port is similar to the procedure described

above for configuring the E1 port.

1 2 ... 68 69 70 71 72 73 74 75 76 77 78 ... 147 148

Pas de commentaire

RAD Data comm IPmux-11 Spécifications Page 73