RAD Data comm E1 Interface Converter RIC-E1 Spécifications télécharger pdf (Page 49)

IR-ETH/QN Options C-1

Appendix C

IR-ETH/QN Interface Module

The IR-ETH/QN interface module includes a high performance self-learning Fast

Ethernet bridge, which is connected to the LAN via a single 10BaseT or 100BaseT

port, operating in full or half duplex and providing simple and cost-effective

interconnection between 10/100BaseT LANs. The IR-ETH/QN interface module

also supports IEEE 802.1p frames and IEEE 802.1q frames, enabling VLAN

applications.

The module automatically learns MAC addresses of the LAN to which it is

connected. Its LAN table stores up to 1,024 addresses with 5-minute automatic

aging.

Filtering and forwarding is performed at the maximum theoretical rate of

150,000 packets per second (wire speed). The buffer with 0.512 Mbit SRAM can

hold 85 frames with a throughput latency of one frame. The forwarding of the

multicast messages from LAN to WAN can be disabled.

Figure C-1 shows a typical application using RIC-E1 with IR-ETH/QN module.

RIC-E1

10/100BaseT LAN

G.703

Network

Figure C-1. Typical Application of RIC-E1 with IR-ETH/QN Module

C.1 IR-ETH/QN Options

Standalone RIC-E1

Figure C-2 shows the rear panel of the standalone RIC-E1, equipped with

IR-ETH/QN module. Table C-1 lists the module's RJ-45 connector pinout.

100M

LINK

10/100BASE-T

ACT

LINK

TX RX

Figure C-2. Rear Panel of RIC-E1 with IR-ETH/QN Module

1 2 ... 44 45 46 47 48 49 50 51 52 53 54 ... 93 94

Pas de commentaire

RAD Data comm E1 Interface Converter RIC-E1 Spécifications Page 49