Rad-data-comm ASM-60 Manuel d'utilisateur télécharger pdf (Page 48)

Appendix C IR-IP Interface Module ASM-60 Installation and Operation Manual

C-4 IR-IP Management Subsystem, General

C.4 IR-IP Management Subsystem, General

Introduction

The IR-IP interface module management subsystem supports the following

functions:

• Preliminary configuration

• Configuration of management access parameters

• Advanced configuration of IR-IP parameters

• Collection and display of statistical performance data

• Maintenance functions, which include:

 Software downloading

 Resetting of various subsystems

 Display of error log

 Ping utility, for checking IP connectivity.

The management subsystem of the IR-IP interface module is a separate,

independent entity, and therefore it cannot be managed through the ASM-60

management subsystem.

The communication with the IR-IP management subsystem is made through the

local LAN interface connector of the IR-IP module, designated 10BASE-T, using

the Telnet protocol. Passwords can be used to prevent unauthorized access.

Accessing the IR-IP Management Subsystem

The IR-IP interface module must be configured in accordance with the specific

requirements of the user’s application before it can be used in the user’s network.

As a result, it is not possible to supply default parameters to enable IR-IP to start

service without any preliminary configuration.

Therefore, to enable the user to establish Telnet communication and configure

IR-IP, IR-IP is delivered with a default set of parameters. The default parameters

are automatically used:

• Before the IP router is configured by the user, e.g., when a new ASM-60 with

IR-IP interface module is put into operation

• After the user’s configuration parameters have been erased.

When the factory-default parameters are used, the ERR indicator located on the

ASM-60 rear panel, near the IR-IP Ethernet interface connector flashes rapidly

(about three times per second).

The flashing of the ERR indicator also serves as a warning to the user that the IR-IP

WAN (VDSL) interface does not send, nor does it receive packets, and therefore IR-

IP can be accessed only from the LAN.

After configuring IR-IP, it starts normal operation and routes the traffic in

accordance with the user-selected configuration parameters.

To change the parameters of an already-configured IR-IP, establish communication

from a Telnet host using the assigned IP address.

Note

1 2 ... 43 44 45 46 47 48 49 50 51 52 53 ... 73 74

Commentaires sur ces manuels

Pas de commentaire

Rad-data-comm ASM-60 Manuel d'utilisateur Page 48

Commentaires sur ces manuels

Produits connexes et manuels pour Matériel Rad-data-comm ASM-60