RAD Data comm Megaplex-2100 Informations techniques télécharger pdf (Page 72)

Chapter 1 Edit Configuration Mode RADview-PC/TDM Megaplex-2100/2104 User’s Manual

1-62 Port Level Configuration Operations

Parameter Possible Values / Remarks

OOS Signal State of the signaling bits when the link is in out-of-service (OOS) state:

Forced Idle – Signaling bits A and B are idle when the link is in out-of-service

state. In addition, if the line type is ESF, signaling bits C and D are also idle.

Forced Busy - Signaling bits A and B are busy when the link is in out-of-service

state. In addition, if the line type is ESF, signaling bits C and D are also busy.

Busy Idle - Signaling bits A and B are busy for 2.5 seconds, then become idle

until the out-of-service state ends. In addition, if the line type is ESF, signaling bits

C and D are idle for 2.5 seconds before switching to busy state.

Idle Busy - Signaling bits A and B are idle for 2.5 seconds, then become busy

until the out-of-service state ends. In addition, if the line type is ESF, signaling bits

C and D are busy for 2.5 seconds before switching to idle state.

Signaling Profile 1, 2, 3, 4, 5

IP Address IP Address

IP Mask IP Mask

Echo Canceller

Off

, On



To display bundle parameters for an ML-IP internal port:

1. In the Card View, click the required port.

2. From the Configuration menu, select Bundles...

The Bundles dialog box appears.

1 2 ... 67 68 69 70 71 72 73 74 75 76 77 ... 167 168

Pas de commentaire

RAD Data comm Megaplex-2100 Informations techniques Page 72