RAD Data comm T1 Spécifications télécharger pdf (Page 12)

Quick Start Guide Installation and Operation Manual

2 Operating FOM-E1/T1 FOM-E1/T1 Ver. 2.0

Connecting the Cables

 To connect cables:

1. Connect the E1/T1 electrical interface.

2. Connect the fiber optic interface.

3. Connect the power cable (first to the modem, then to the mains).

Operation starts when the power is applied to the rear panel power

connector.

2. Operating FOM-E1/T1

1. Check that SW1 of the DIP switch is set to OFF.

2. Verify LED status. All the LED indicators should be OFF, except for the PWR

indicator.

3. If there is an indication of a malfunction or fault, run a diagnostic test.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 47 48

Pas de commentaire

RAD Data comm T1 Spécifications Page 12