RAD Data comm LA-210 Manuel d'utilisateur télécharger pdf (Page 17)

User’s Manual Chapter 2 Installation and Operation

RV-EMS/NGN LA-210 Pre-configuring LA-210 for Network Management 2-5

When you allow sending general and alarm traps to a network manager, you can

mask or unmask each trap (general or interface-specific). See the following

section.

³ To add a network management station:

1. From the Management menu (Configuration > System > Management), select

Managers List.

The Managers List menu appears (see

Figure

2-3

2. In the Managers list, select the IP address, which is 0.0.0.0 by default, and

then select Change Cell.

The Manager is assigned.

3. To mask or unmask a manager, select the desired manager’s Manager Trap

Mask entry and select Change Cell.

LA-210

Configuration>System>Management>Managers List

Manager ID Manager IP Manager Trap Mask

1. 0.0.0.0 Mask

2. 0.0.0.0 Unmask

3. 0.0.0.0 Unmask

4. 0.0.0.0 Unmask

5. 0.0.0.0 Unmask

6. 0.0.0.0 Unmask

7. 0.0.0.0 Unmask

8. 0.0.0.0 Unmask

9. 0.0.0.0 Unmask

10. 0.0.0.0 Unmask

1. Change Cell

A – add R – remove X – clear table

ESC-prev.menu; !-main menu; &-exit; ?-help

Figure

2-3. Manager List Menu (LA-210)

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 157 158

Pas de commentaire

RAD Data comm LA-210 Manuel d'utilisateur Page 17