RAD Data comm FOM-E3 Spécifications Page 12

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 102
  • Table des matières
  • DEPANNAGE
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 11
Quick Start Guide Installation and Operation Manual
2 Configuring RICi-E3, RICi-T3 RICi-E3, RICi-T3 Ver. 1.0
2. Configuring RICi-E3, RICi-T3
Configure RICi-E3, RICi-T3 to the desired operation mode via an ASCII terminal
connected to the rear panel CONTROL port. Alternatively, you can manage
RICi-E3, RICi-T3 over Telnet, a PC running a Web browsing application, or SNMP via
the Ethernet or E3 port.
Remote management requires assigning an IP address.
Starting a Terminal Session
To start a terminal session:
1. Connect an ASCII terminal to the CONTROL port at the front panel. The
default settings are as follows:
Baud Rate: 115,200 bps
Data Bits: 8
Parity: None
Stop Bits: 1
Flow Control: None.
2. To optimize the view of the system menus, do the following:
Set the terminal emulator to VT100.
If you are using HyperTerminal, set the terminal mode to the 132-column
mode.
3. Enter your user name and password and proceed with the management
session.
The RICi-E3, RICi-T3 default user name is su (lower case). The default password is
1234.
Note
Note
Vue de la page 11
1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 101 102

Commentaires sur ces manuels

Pas de commentaire