RAD Data comm E1 Spécifications télécharger pdf (Page 49)

MiTOP-E1/T1 Ver. 1.0 Configuring MiTOP-E1/T1 for Management 4-1

Chapter 4

Configuration

This chapter illustrates the configuration MiTOP-E1/T1 screens and explains their

parameters.

The menu tree of the MiTOP-E1/T1 management software is shown in

Chapter 3

4.1 Configuring MiTOP-E1/T1 for Management

Before configuring MiTOP-E1/T1 make sure to assign a new IP address, an IP mask

and a default gateway value to the unit’s host, as explained in

Chapter 3

. Once

the MiTOP-E1/T1 host IP parameters are set, perform the following steps in order

to configure MiTOP-E1/T1 for management:

•

Entering Device Information

•

Configuring the Host IP Parameters

•

Defining Management Access Permissions

•

Controlling Management Access

•

Enabling/Disabling I2C Cycle Stretching.

Entering Device Information

The MiTOP-E1/T1 management software allows you to assign a name to the unit,

add its description, specify its location to distinguish it from the other devices

installed in your system, and assign a contact person.

³ To enter device information:

1. From the Device Info menu (Configuration > System > Management > Device

Info), select Device Name and enter a desired name for the MiTOP-E1/T1 unit.

2. In the Device Location field, enter the desired name for the current

MiTOP-E1/T1 location.

3. In the Contact Person field, enter the name of a contact person.

1 2 ... 44 45 46 47 48 49 50 51 52 53 54 ... 117 118

Pas de commentaire

RAD Data comm E1 Spécifications Page 49