RAD Data comm ASMI-450 Manuel d'utilisateur télécharger pdf (Page 13)

LRS-24 RADview/TDM Pre-configuring for Network Management 2-1

Chapter 2

Installation and Operation

2.1 Pre-configuring for Network Management

Perform the preliminary hardware configuration of LRS-24 using a terminal

emulation program.

Basic tasks include:

• Connecting the LRS-24 to a local terminal

• Viewing terminal commands

• Defining agent parameters.

 To connect LRS-24 to a local terminal:

• Connect the RS-232 connector to the CM-2 RS-232 port, located on the CM-2

card.

The terminal emulation program uses the following communication

parameters:

 Baud rate: 38,400

 Data bits: 8

 Parity: None

 Stop bits: 1

 Flow control: None.

 To define LRS-24 and SNMP agent parameters:

1. From the Main menu, select System Configuration.

The LRS Chassis Setup Screen appears (

Figure 2-1

2. Type in the name of the chassis, and press <Enter>.

3. To move to the next line, press <Tab>.

4. Repeat the above steps to define the remaining agent parameters.

Figure 2-1

shows

a typical, completed data form.

SNMP community names are case-sensitive.

Note

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 159 160

Pas de commentaire

RAD Data comm ASMI-450 Manuel d'utilisateur Page 13