RAD Data comm Vmux-210 Informations techniques télécharger pdf (Page 51)

User's Manual Chapter 3 Configuration Management

Vmux-210 Ver. 1.0 Setting the Operational Parameters 3-25

Table 3-14. Serial Link SW Cfg Tab Parameters (Cont.)

Parameter Possible Values / Remarks

Loop Detect Enables/disables Loop Detection on the Serial Uplink

Disable, Enable

Default: Disable

Note: This parameter is disabled when HDLC Mode is set to Cisco Bridged ETH.

[Set] Click <Set> to reset the new values in the dialog box

[Cancel] Click <Cancel> to cancel the selections made in the dialog box and close the

box

[Close] Click <Close> to close the dialog box

[Refresh] Click <Refresh> to refresh the data in the dialog box

Copying a Port Configuration

In order to save time and trouble, once a port is configured, its software

configuration can be easily copied to other ports, using the port Copy command.

 To copy a port configuration to another port:

1. In Edit Mode, select an FXS Port.

2. From the Configuration menu, select Copy….

3. Click a destination port to select it.

To select multiple destination ports, hold down the Control (Ctrl) key and click

the desired destination ports.

4. If a confirmation dialog box appears, click <OK> to confirm that you want to

copy any way and replace the existing port configurations.

The configuration is copied from the selected source port to the selected

destination ports.

Figure 3-16. Port Copy Dialog Box

1 2 ... 46 47 48 49 50 51 52 53 54 55 56 ... 137 138

Pas de commentaire

RAD Data comm Vmux-210 Informations techniques Page 51