RAD Data comm Vmux-210 Informations techniques télécharger pdf (Page 11)

Vmux-210 Ver. 1.0 Pre-configuring Vmux-210 for Network Management 2-1

Chapter 2

Installation and Operation

This chapter describes how to configure Vmux-210 for management and explains

how to perform the following tasks:

• Pre-configuring Vmux-210 for Network Management

• Connecting Vmux-210 to the Management Station

• Launching RADview Vmux-210

• Using the Graphical User Interface

2.1 Pre-configuring Vmux-210 for Network

Management

To remotely administer Vmux-210 via a Network Management Station (NMS), it is

necessary to first configure some basic Vmux-210 parameters via an ASCII

terminal. The following steps are required:

1. Connecting a Terminal to the Control Port

2. Disabling the Router

3. Configuring the host IP parameters (IP address, IP mask, default gateway,

SNMP Communities)

4. Defining the Network Management Station in the Manager List.

For more detailed information about configuring Vmux-210 for Network

Management, see

Chapter 4 of the Vmux-210 Installation and Operation Manual

Connecting a Terminal to the Control Port

In order to configure the basic IP parameters, it is necessary to connect an ASCII

terminal to the Vmux-210 control port and log in.

 To configure the Vmux-210 system parameters:

1. Configure an ASCII terminal to:

 One start bit

 Eight data bits

 No parity

 One stop bit

 No flow control

 VT100 emulation.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 137 138

Pas de commentaire

RAD Data comm Vmux-210 Informations techniques Page 11