RAD Data comm IPmux-11 Informations techniques télécharger pdf (Page 33)

User's Manual Chapter 3 Configuration Management

RADview-SC/TDMoIP IPmux-11 Setting the Operational Parameters 3-17

Parameter Possible Values / Remarks

Mark Signaling

Code

Trunk conditioning signal value after alarm detection

E1, T1-ESF: 1..F

T1-SF(D4): 1..4

OOS Code Trunk conditioning data pattern to be sent upon a DS0 fail

Note: When Line Type is set to Unframed, OOS Code is grayed out and its value cannot

be changed.

AIS Transmit

Enable, Disable

Trail Mode Enables the end-to-end transfer of TDM OAM in framed mode, when theirTDMoIP

Payload Format is set to V2.

Termination - Trail mode is disabled

Extension - Trail mode is enabled

Configuring the Ethernet Ports

The Ethernet Interface Parameters command enables you to configure the various

parameters of the Ethernet port (the port’s software configuration).



To set configuration parameters for the Ethernet interface:

1. Click the User or Network Ethernet port.

2. Select Configuration > Parameters...

The Network Ethernet Interface Parameters dialog box appears

(

Figure 3-14).

The User Ethernet rate is the smaller value of User Rate Limit and

(100–TDMoIP traffic).

Figure 3-14. Ethernet Interface Parameters Dialog Box

Note

1 2 ... 28 29 30 31 32 33 34 35 36 37 38 ... 89 90

Pas de commentaire

RAD Data comm IPmux-11 Informations techniques Page 33