RAD Data comm FLM-1 Spécifications télécharger pdf (Page 24)

Chapter 2 - Installation and Setup FLM-1

Installation & Operation Manual

2-8 Installation and Setup 16/01/01 11:12 AM

Warning

Before connecting power to the unit, verify that the socket outlet is

provided with a protective earth contact. If you are using an extension

cord (power cable) make sure it is grounded as well.

Interrupting the protective (grounding) conductor (inside or outside the

unit), or disconnecting the protective earth terminal can make this unit

dangerous.

Make sure that only fuses of the required rating, as marked on the rear

panel, are used for replacement. Do not use repaired fuses or

short-circuit the fuse holder. Always disconnect the mains cable before

removing or replacing the fuse. Whenever it is likely that the fuse

protection has been damaged, make the unit inoperative.

To connect power to FLM-1, simply insert its power cord into the power

socket.

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 33 34

Pas de commentaire

RAD Data comm FLM-1 Spécifications Page 24