RAD Data comm FOM-E3 Manuel d'instructions télécharger pdf (Page 22)

Chapter 2 Installation and Setup RIC-E3/ETH, RIC-T3/ETH Installation and Operation Manual

2-6 Installation and Setup

Table 2-4. Ethernet Interface DIP Switch Settings (Cont.)

Section Name Description Possible Settings Factory Setting

7 MUL Controls LAN to WAN

multicasting

ON – Multicast messages from LAN to

WAN are blocked

OFF – Multicast messages from LAN to

WAN are not blocked

OFF

8 SCR Controls the scrambling of

Ethernet frames

ON – Ethernet frames are scrambled

OFF – Ethernet frames are left

unchanged

OFF

Closing the Case

Once you finish the internal settings, you have to close the RIC-E3/ETH and

RIC-T3/ETH case.



To close the RIC-E3/ETH or RIC-T3/ETH case:

1. Slide the unit's interior back into the case.

2. Screw in the two rear panel screws to fasten the main board in the case.

Connecting the Interfaces

Figure 2-5 shows a typical rear panel of a standard RIC-E3/ETH unit and identifies

connector locations for the AC version.

The RIC-E3/ETH and RIC-T3/ETH rear panels contain also LAN status indicators,

which duplicate the front panel LAN LEDs. The LINK and ACT indicators are

located on the Ethernet interface connector.

LINE 10/100BASE-T

100M

ACT LINK

IN OUT

ALARMS

Figure 2-5. RIC-E3/ETH Rear Panel

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 32 33

Pas de commentaire

RAD Data comm FOM-E3 Manuel d'instructions Page 22