RAD Data comm ASM-MN-214 Spécifications télécharger pdf (Page 25)

Installation and Operation Manual Quick Start Guide

ASM-MN-214 Ver. 1.0 Installing ASM-MN-214 9

 Fifth screw – to ground (optional).

Modems operating over 2-wire lines use XMT terminals for the receive and

transmit pairs.

4. If required, attach the appropriate CIA (CIA/X.21/1, CIA/V.35/1, CIA/ETH) or

V.36 adapter cable to the DB-25 connector on the chassis rear panel.

5. Connect the DTE cable to the DB-25 connector, other side of CIA or adapter

cable (depending on your version of the card interface).

6. Connect power to the ASM-MN-214 chassis:

 To connect AC power, connect the power cable to the mains supply.

 To connect DC power, refer to the 24 VDC supplement or 48 VDC

supplement.

Note

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 31 32

Pas de commentaire

RAD Data comm ASM-MN-214 Spécifications Page 25